MyoLift™ Triwave Microcurrent Facial Device

Microcurrent is an all natural solution to anti-ageing, and an effective aesthetic treatment available for facial toning with long-lasting results, without the aid of a medical device.

As we age, muscles lose ATP (adenosine triphosphate) which is the energy of our skin cells and muscle tissue. The skin starts to fall, expression lines develop and the facial muscles that are not used often, begin to sag.

The MyoLift™ Triwave skin treatment uses microcurrent technology to establish visible results. This gentle, non-aggressive, non-invasive and progressive treatment results in skin tightening, toning and lifting. The results from microcurrent facials are so dramatic, they’re often referred to as ‘non-surgical facelifts.’

Make sure the device is disconnected from the wall socket and the probe applicators are disconnected from the device.

With gloves on, spray state approved disinfectant onto a paper towel and wipe down the device and probes thoroughly. Allow the disinfectant to remain on the probes for the recommended time. Using a wet paper towel, wipe the probes free of disinfectant. Allow a few minutes to air dry. Store the sanitary probes in a closed container or bag.

Step 1: Cleanse the face and pat dry. Apply a water-based serum to the face and neck.

Step 2: Spray the skin with 7E RePlenish Conductive Spritzer until thoroughly saturated.

Step 3: Apply the selected 7E Conductive Tx Gel by ‘painting as you go’ to the area. If the skin becomes dry or tacky, mist the 7E RePlenish Conductive Spritzer.

Step 4: Turn on the device and press the ‘Run/Pause’ button. The conductivity bar will start to flash.

Step 5: Always begin the treatment with Rejuve Mode, followed by Erase and Educate Mode.

Step 6: Once your full treatment is complete, wipe any excess product from the skin with a warm towel.

Expert Advice: 7E MyoLift™ treatments may be repeated 3 times a week until the desired results are achieved. Maintain results once every 4 weeks. If 3 months have passed since the last treatment, the series needs to be restarted. 7E recommends that microcurrent treatments are performed in a series of 2 to 4 treatments per week initially.

The following are general and approximate guidelines for frequency of treatment:

20-35 years: Preventative, can be performed once to twice a month.

35-40 years: Initial series of 2 treatments per week for 1 month and to follow with maintenance once a month thereafter.

45-50 years: Initial series of 2 treatments per week for 2 months and to follow with maintenance once a month thereafter.

50-60 years: Initial series of 3 treatments per week for 2 months with maintenance twice a month thereafter.

60+ years: Initial series of 3 treatments per week for 3 months with maintenance twice a month thereafter.